| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Tire Pressure Monitoring | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002L8J009X |
| Title: TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ECU
|
(a) Install the ECU with the bolt. Torque: 7.5 N·m (77 kgf·cm, 66 in·lbf) |
(b) Connect the ECU connector.
(c) Attach the clamp.
2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH
3. INSTALL REAR SEAT COVER CAP
4. INSTALL LUGGAGE COMPARTMENT NO. 1 TRIM HOOK
5. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE
6. INSTALL REAR DOOR SCUFF PLATE RH
7. INSTALL REAR STEP COVER
8. INSTALL REAR NO. 2 SEAT ASSEMBLY
(a) for Power Seat:
Install the rear No. 2 seat
.
(b) for Manual Seat:
Install the rear No. 2 seat
.
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
10. PERFORM REGISTRATION
(a) Perform registration
.
11. CHECK TIRE INFLATION PRESSURE
(a) Check the tire inflation pressure when the tire is cold
.
12. PERFORM SYSTEM INITIALIZE
(a) Perform system initialize
.
13. CHECK TIRE PRESSURE AFTER REPAIRS
(a) After repairs, confirm that the actual tire pressures are displayed in the Data List
.
|
|