Home › Engine/Hybrid System › Engine Control › 3UR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Engine Control
Model Year: 2008 Model: LX570 Doc ID: RM000002PQD00GX
Title: 3UR-FE ENGINE CONTROL: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR



(a) Install a new gasket to the sensor.

(b) Using a 19 mm deep socked wrench, install the sensor.

Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)

(c) Connect the sensor connector.

2. ADD ENGINE COOLANT 3UR-FE COOLING: COOLANT: REPLACEMENT (2008 LX570)+

3. INSPECT FOR COOLANT LEAK 3UR-FE COOLING: COOLING SYSTEM: ON-VEHICLE INSPECTION (2008 LX570)+

4. INSTALL V-BANK COVER SUB-ASSEMBLY 3UR-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: INSTALLATION (2008 LX570)+

5. INSTALL UPPER RADIATOR SUPPORT SEAL EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

6. INSTALL ENGINE ROOM SIDE COVER RH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

7. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

8. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 LX570)+

9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION (2008 LX570)+

10. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION (2008 LX570)+