Home › Drivetrain › Transfer/4wd/Awd › JF2A TRANSFER / 4WD / AWD: TRANSFER CASE REAR OIL SEAL
Last Modified: 11-27-2007 1.6 A
Service Category: Drivetrain Section: Transfer/4wd/Awd
Model Year: 2008 Model: LX570 Doc ID: RM0000030S8006X
Title: JF2A TRANSFER / 4WD / AWD: TRANSFER CASE REAR OIL SEAL: REPLACEMENT (2008 LX570)

REPLACEMENT

1. REMOVE PROPELLER SHAFT ASSEMBLY

(a) Remove the propeller shaft assembly DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: REMOVAL (2008 LX570) .

2. REMOVE REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY JF2A TRANSFER / 4WD / AWD: TRANSFER ASSEMBLY: DISASSEMBLY (2008 LX570)+

3. REMOVE TRANSFER CASE REAR OIL SEAL

(a) Using SST, tap out the oil seal.

SST: 09308-00010

NOTICE:

Be careful not to damage the oil seal and rear transfer case contact surface.

4. INSTALL TRANSFER CASE REAR OIL SEAL

(a) Apply transfer oil to the spline of the output shaft.

(b) Using SST and a hammer, tap in a new oil seal until its surface is flush with the housing upper surface.

SST: 09649-17010

SST: 09950-70010

09951-07150

5. INSTALL REAR OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY JF2A TRANSFER / 4WD / AWD: TRANSFER ASSEMBLY: REASSEMBLY (2008 LX570)+

6. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Install the propeller shaft assembly DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: INSTALLATION (2008 LX570) .