INSTALLATION

1. INSTALL POWER BACK DOOR UNIT ASSEMBLY

(a) Attach the 2 claws to install the power back door unit.

(b) Install the 4 bolts.

Torque: 14 N·m (143 kgf·cm, 10 ft·lbf)

(c) Connect the connector.

2. INSTALL REAR UPPER PILLAR GARNISH RH

3. INSTALL BACK DOOR SERVICE HOLE COVER RH

4. INSTALL BACK DOOR SIDE GARNISH RH

5. INSTALL CENTER BACK DOOR GARNISH

6. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH

7. INSTALL REAR SEAT COVER CAP (for Rear No. 2 Seat with Manual Folding-up Function)

8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

9. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

10. INSTALL REAR DOOR SCUFF PLATE RH

11. INSTALL REAR STEP COVER

(1) Remove the rear No. 2 seat assembly RH .

HINT:

Use the same procedures described for the LH side.

(b) w/ Manual Folding-up Function:

(1) Remove the rear No. 2 seat assembly RH .

HINT:

Use the same procedures described for the LH side.

When disconnecting the cable, some systems need to be initialized after the cable is reconnected .

14. INSTALL REAR NO. 2 SEAT HINGE COVER RH

15. INSTALL REAR SEAT CUSHION HINGE COVER RH

16. INSTALL ENGINE ROOM SIDE COVER LH