Home › Engine/Hybrid System › Lubrication › 3UR-FE LUBRICATION: OIL LEVEL SENSOR
Last Modified: 11-27-2007 1.6 A
Service Category: Engine/Hybrid System Section: Lubrication
Model Year: 2008 Model: LX570 Doc ID: RM0000039KV001X
Title: 3UR-FE LUBRICATION: OIL LEVEL SENSOR: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL ENGINE OIL LEVEL SENSOR

(a) Install a new gasket and the oil level sensor with the 4 bolts.

Torque: 7.0 N·m (71 kgf·cm, 62 in·lbf)

(b) Connect the oil level sensor connector.

2. CONNECT OIL COOLER PIPE ASSEMBLY

(a) Connect the oil cooler pipe with the 2 bolts.

Torque: 14 N·m (143 kgf·cm, 10 ft·lbf)

3. ADD ENGINE OIL 3UR-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 LX570)+

4. INSPECT FOR OIL LEAK 3UR-FE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT (2008 LX570)+

5. INSPECT ENGINE OIL LEVEL 3UR-FE LUBRICATION: LUBRICATION SYSTEM: ON-VEHICLE INSPECTION (2008 LX570)+

6. INSTALL NO. 2 ENGINE UNDER COVER 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 LX570)+

7. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 LX570)+

8. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION (2008 LX570)+

9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION (2008 LX570)+