[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
23 -AUTOMATIC TRANSMISSION > 23A-CVT > TROUBLESHOOTING<S-AWC><S-AWC> > DIAGNOSIS CODE PROCEDURES > CODE NO. U1195 CODING NOT COMPLETE
Code No. U1195: Coding Not Completed
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
  • When the diagnosis code No.U1195 is set in AWC-ECU, the diagnosis code may also be set in ETACS-ECU. When the diagnosis code is set in ETACS-ECU, perform the diagnosis of the diagnosis code for ETACS-ECU first.
 
 
OPERATION
AWC-ECU receives the vehicle information stored in ETACS-ECU via CAN bus lines.
 
 
DIAGNOSIS CODE SET CONDITIONS
The code is set when the AWC-ECU coding has not been performed.
 
 
PROBABLE CAUSES
  • Malfunction of the CAN bus line
  • A variant coding for the ETACS-ECU has not been implemented.
  • Malfunction of ETACS-ECU
  • Malfunction of AWC-ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
Use M.U.T.-IIISE to perform the CAN bus diagnosis.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. M.U.T.-IIISE other system diagnosis code.
Check the ETACS diagnosis code (Refer to GROUP 54A - Troubleshooting ).
Is the diagnosis code set?
Perform the relevant troubleshooting.
Go to Step 3.
 
STEP 3. ETACS-ECU coding data check
Using the M.U.T.-IIISE, check if there is any abnormality to the coding data stored in the ETACS-ECU.
Is the check result normal?
Go to Step 4.
Replace the ETACS-ECU (Refer to GROUP 54A - ETACS-ECU ).
 
STEP 4. Check whether the diagnosis code is set again.
Is diagnosis code No.U1195 set?
Replace the AWC-ECU (Refer to ).
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).