[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
36 -PARKING BRAKE > TROUBLESHOOTING<ELECTRIC PARKING BRAKE><ELECTRIC PARKING BRAKE> > DIAGNOSIS CODE PROCEDURES > CODE No. U0100 ENGINE CAN TIMEOUT
Code No. U0100: Engine CAN timeout
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
  • If diagnosis code U0100 is set in electric parking brake ECU, always diagnose the CAN bus line. If there is any fault in the CAN bus lines, an incorrect diagnosis code may be set. In this case, the set diagnosis code is not highly reliable.
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
The electric parking brake ECU communicates with the engine-ECU via the CAN bus lines.
 
 
DIAGNOSIS CODE SET CONDITIONS
If the ECU cannot receive any signal from the engine-ECU via CAN for 500 ms or more, this diagnosis code will be set.
 
 
PROBABLE CAUSES
  • The CAN bus line is defective.
  • Power supply circuit for the engine-ECU fails
  • Malfunction of the engine-ECU
  • Malfunction of the electric parking brake ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnosis
Use the M.U.T.-IIISE to diagnose the CAN bus lines.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
 
STEP 2. Check for diagnosis codes of other systems.
Check whether an engine "time-out" related diagnosis code is set in other ECUs (Refer to GROUP 54C - CAN-Related Diagnosis Code Table ).
Is the diagnosis code set?
Go to Step 3.
Go to Step 4.
 
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set.
(1) Erase the diagnosis code.
(2) Turn the ignition switch to the LOCK (OFF) position.
(3) Turn the ignition switch to the ON position.
(4) Check if the diagnosis code is set.
Is diagnosis code No. U0100 set?
Replace the engine-ECU (Refer to GROUP 13A - engine-ECU ).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
 
STEP 4. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set.
(1) Erase the diagnosis code.
(2) Turn the ignition switch to the LOCK (OFF) position.
(3) Turn the ignition switch to the ON position.
(4) Check if the diagnosis code is set.
Is diagnosis code No. U0100 set?
Replace the electric parking brake ECU (Refer to ).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).