DTC P268A
Precautions: General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
P268A: Fuel Injector Calibration Not Learned / Programmed Injector calibration code is not registered in ECM. (1 D/C detection logic) |
•No injector calibration code
•ECM |
DTC Troubleshooting
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Was “Engine and Emission Control System Check” performed?
|
Go to Step 2.
|
|
| 2 |
Injector calibration code check
1)When ignition is “OFF”, connect SUZUKI scan tool to DLC.
2)Set ignition “ON”.
3)Check registered injector calibration code.
Is registered injector calibration code correct?
|
Go to Step 3.
|
Register correct injector calibration code to ECM.
|
| 3 |
DTC recheck
1)Clear DTC.
2)Set ignition “ON”.
3)Check DTCs.
Is DTC P268A still detected?
|
Replace ECM and recheck DTC.
|
End.
|