Speed Signal Check
Precautions: General safety (00)
Troubleshooting
WARNING:
If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.
•Select a level road with no traffic to minimize the risk of accident.
•Perform the test extremely carefully.
•Perform the road test with 2 persons, a driver and a tester.
•Perform the test extremely carefully.
•Perform the road test with 2 persons, a driver and a tester.
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Parameter check
1)When ignition is “OFF”, connect SUZUKI scan tool to DLC.
2)Perform a road test and drive vehicle at constant speed of 30 km/h (19 mile/h).
3)Check that “Vehicle Speed” displayed on SUZUKI scan tool is Approx. 30 km/h (19 mile/h).
Is check result OK?
|
End.
|
Go to Step 2.
|
| 2 |
DTC check
1)Check ESP® control module for DTC.
Is there any DTC related to wheel speed sensor?
|
Go to troubleshooting for applicable DTC.
|
Go to Step 3.
|
| 3 |
DTC check
1)Check ECM and ESP® control module for DTC.
Is there any DTC related to CAN?
|
Go to troubleshooting for applicable DTC.
|
Go to Step 4.
|
| 4 |
ECM replacement
1)Replace ECM.
2)Recheck parameter referring to “Step 1”.
Is check result OK?
|
End.
|
Replace ESP® control module.
|