DTC B1A24 / B1A25 / B1A26 / B1A27

Precautions: Precautions for Diagnosing Trouble · Precautions for Control Systems · General safety (00)

DTC Detecting Condition and Trouble Area

DTC detecting condition	Trouble area
B1A24: Right Front Tire Pressure Sensor Battery Voltage Low B1A25: Left Front Tire Pressure Sensor Battery Voltage Low B1A26: Right Rear Tire Pressure Sensor Battery Voltage Low B1A27: Left Rear Tire Pressure Sensor Battery Voltage Low TPMS control module receives battery run down signal from tire pressure sensor for specified time when tire temperature is higher than –10 °C (14 °F).	•Tire pressure sensor No.1, No.2, No.3 and/or No.4 •TPMS control module

DTC Confirmation Procedure

WARNING:

If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.

•Select a level road with no traffic to minimize the risk of accident.
•Perform the test extremely carefully.
•Perform the road test with 2 persons, a driver and a tester.

1)Set ignition “OFF” and leave ignition “OFF” for 20 minutes or more.

2)Drive vehicle at 25 km/h (16 mile/h) or more for 30 minutes or more when outside air temperature is higher than –10 °C (14 °F).

DTC Troubleshooting

Step	Action	Yes	No
1	Do you have recommended tool?	Go to Step 2.	Go to Step 4.
2	Tire pressure sensor check 1)Using recommended tool, check DTC detected tire pressure sensor. Recommended tool “VT55” or “VT30” made by ATEQ Is check result OK?	Go to Step 3.	Go to Step 4.
3	DTC check 1)Clear DTC. 2)Perform DTC Confirmation Procedure and then recheck DTC. Is DTC B1A24, B1A25, B1A26 or B1A27 still detected?	Go to Step 4.	Check for intermittent trouble.
4	DTC check 1)Replace DTC detected tire pressure sensor. 2)Clear DTC. 3)Perform DTC Confirmation Procedure and then recheck DTC. Is DTC B1A24, B1A25, B1A26 or B1A27 still detected?	Replace TPMS control module and recheck DTC.	End.