DTC P1360

Precautions: Precautions for Diagnosing Trouble · Precautions for Servicing ENG A-STOP System · Precautions for Replacing ENG A-STOP Control Module · Precautions for Control Systems · General safety (00)

DTC Detecting Condition and Trouble Area

DTC detecting condition	Trouble area
P1360: ENG A-STOP Battery Performance 7 V or lower battery voltage is detected specified number of times consecutively.	•Main power supply circuit •Battery •ENG A-STOP control module

Circuit Diagram

[A]:	ENG A-STOP control module connector (View: [a])	A2:	ENG A-STOP control module power supply circuit 2	1.	ENG A-STOP control module
[B]:	D16AA model	B1:	ENG A-STOP control module ground circuit 1	2.	“A-STOP” fuse
A1:	ENG A-STOP control module power supply circuit 1	B2:	ENG A-STOP control module ground circuit 2	3.	“BTRY” fuse

DTC Confirmation Procedure

WARNING:

If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.

•Select a level road with no traffic to minimize the risk of accident.
•Perform the test extremely carefully.
•Perform the road test with 2 persons, a driver and a tester.

M/T model

1)Warm up engine to normal operating temperature.

2)Drive vehicle at more than 10 km/h (6 mile/h).

3)Stop vehicle and shift gear to “Neutral”.

4)Release clutch pedal.

5)Depress clutch pedal.

6)Set ignition “OFF”.

7)Repeat Step 2) – 5) once.

A/T model / Twin clutch system model

1)Warm up engine to normal operating temperature.

2)Drive vehicle at more than 10 km/h (6 mile/h).

3)Stop vehicle.

4)Release brake pedal.

5)Set ignition “OFF”.

6)Repeat Step 2) – 4) once.

DTC Troubleshooting

Step	Action	Yes	No
1	DTC check Is DTC P1302 also detected?	Go to troubleshooting for applicable DTC.	Go to Step 2.
2	Battery check 1)Check battery. •M16A model: •K14C model: •D16AA model: Is check result OK?	Go to Step 3.	Replace the battery.
3	Charging system check 1)Check charging system. •M16A model: •K14C model: •D16AA model: Is check result OK?	Replace ENG A-STOP control module and recheck for DTC.	Repair defective part(s) in charging system.