Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1337/37    Different Diameter Tire Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensor. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must be equal.

DTC No.
DTC Detection Condition
Trouble Area
C1337/37
When either of the following condition is detected:
  1. Diameter is different between the 2 front wheels and the 2 rear wheels.
  2. Wheel speed sensor fault
  1. Speed sensor
  2. Speed sensor rotor
  3. Speed sensor circuit
  4. Tire size

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.CHECK TIRE SIZE
  1. Check tire size and condition of all 4 wheels.



NG
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME IN SIZE
OK


2.INSPECT SPEED SENSOR ROTOR
  1. Check the front speed sensor circuit (Click here) and rear speed sensor circuit (Click here).



NG
REPLACE SPEED SENSOR ROTOR
OK


3.INSPECT SPEED SENSOR
  1. Check the front speed sensor circuit (Click here) and rear speed sensor circuit (Click here).



NG
REPLACE SPEED SENSOR
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SPEED SENSOR)
  1. Check the front speed sensor circuit (Click here) and rear speed sensor circuit (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Drive the vehicle at a speed of approximately 13 mph (20 km/h) or more for 60 seconds or more.

  1. Check if the same pending DTC is detected (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.


    Result:

    Condition
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID