Home › SUSPENSION & AXLE › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM

AIR SUSPENSION SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DIAGNOSIS SYSTEM


    F100115E31
  1. Inspect the battery voltage.

    Battery voltage:
    11 to 14 V

    If voltage is below 11 V, recharge the battery before proceeding.

  2. Check DLC3.
    The suspension control ECU uses the ISO 9141-2 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 9141-2 format.
    Verify the conditions listed in the table below:

    Symbols (Terminal No.)
    Terminal Description
    Condition
    Specified Condition
    SIL (7) - SG (5)
    Bus "+" line
    During communication
    Pulse generation
    CG (4) - Body ground
    Chassis ground
    Always
    Below 1 Ω
    SG (5) - Body ground
    Signal ground
    Always
    Below 1 Ω
    BAT (16) - Body ground
    Battery positive
    Always
    11 to 14 V

    HINT:
    If the intelligent tester display shows UNABLE TO CONNECT TO VEHICLE when the cable of the intelligent tester is connected to the DLC3, the ignition switch is turned ON and the tester is operated, there is a problem on the vehicle side or tester side.

    1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.
    2. If communication is still not possible when the tool is connected to another vehicle, the problem is probably in the tester itself, so consult the service department listed in the tester's instruction manual.

  3. DTCs (Normal mode)

    1. DTCs are memorized in the suspension control ECU and read by using the SST check wire or the intelligent tester (Click here).

      SST
      09843-18040  

  4. Test mode (Input signal check)

    1. By switching from normal mode into test mode, you can inspect the height control switch, height control mode select switch, door courtesy light switch, and stop light switch (Click here).



  5. F041674
  6. Check the indicator light.

    1. Turn the ignition switch to the ON position.

    2. Check that the height control manual indicator light and the height control indicator light come on for 2 seconds.
      If the indicator check result is not normal, proceed to troubleshooting for the height control indicator light circuit (Click here) and the height control OFF indicator light circuit (Click here).