DTC P0128 Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) |
| DTC No. | DTC Detection Conditions | Trouble Areas |
| P0128 | Conditions (a), (b) and (c) are met for 5 seconds (2 trip detection logic): (a) Cold start (b) Engine warmed up (c) ECT less than 75°C (167°F) |
|

| Related DTCs | P0128: Coolant Thermostat |
| Required Sensors / Components (Main) | Thermostat |
| Required Sensors / Components (Related) | Engine Coolant Temperature (ECT) sensor, Intake Air Temperature (IAT) sensor, Vehicle speed sensor, Engine cooling system |
| Frequency of Operation | Once per driving cycle |
| Duration | 15 minutes |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | P0010, P0020 (VVT VSV 1, 2), P0011, P0012 (VVT System1-Advance, Retard), P0021, P0022 (VVT System2-Adavance, Retard), P0031, P0032, P0051, P0052 (A/F Sensor heater Sensor 1), P0100, P0101, P0102, P0103 (MAF Meter), P0110, P0112, P0113 (IAT Sensor), P0115, P0116, P0117, P0118 (ECT Sensor), P0125 (Insufficient ECT for Closed Loop), P0171,P0172 (Fuel System), P0300, P0301, P0302, P0303, P0304, P0305, P0306 (Misfire), P0335 (CKP Sensor), P0340 (CMP Sensor), P0340, P0342, P0343, P0345 (VVT Sensor1, 2), P0351, P0352, P0353, P0354, P0355, P0356 (Ignitor), P0500 (VSS), P2196, P2198(A/F Sensor (Rationality)), P2A00, P2A03 (A/F Sensor (Slow Response)) |
| Battery voltage | 11 V or more |
| Either of following conditions met: | Condition 1 or 2 |
| 1. All of following conditions met: | Condition (a), (b) and (c) |
| (a) ECT at engine start - IAT at engine starts | -15° to 7°C (5° to 45°F) |
| (b) ECT at engine start | -10° to 56°C (14° to 133°F) |
| (c) IAT at engine start | -10° to 56°C (14° to 133°F) |
| 2. All of following conditions met: | Condition (d), (e) and (f) |
| (d) ECT at engine start - IAT at engine start | More than 7°C (45°F) |
| (e) ECT at engine start | 56°C (133°F) or less |
| (f) IAT at engine start | -10°C (14°F) or more |
| Accumulated time that vehicle speed is 80 mph (128km/h) or more | Less than 20 seconds |
| Duration that all of following conditions 1 and 2 met | 5 seconds or more |
| 1. Estimated ECT | 75°C (167°F) or more |
| 2. ECT sensor output | Below 75°C (167°F) |
| TLT | CID | Unit Conversion | Description of Test Data | Description of Test Limit |
| 1 | $01 | Multiply by 0.625 and subtract 40(°C) | ECT sensor output when estimated ECT has reached to malfunction criterion | Malfunction criteria for thermostat |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0128) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Turn the tester on.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0128 | A |
| P0128 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK COOLING SYSTEM |
Check that there is no defect in the cooling system which causes overcool, such as abnormal radiator fan operation, modified cooling system and so on.
|
| ||||
| OK | |
| 3.INSPECT THERMOSTAT |
Remove the thermostat (Click here).
Check the valve opening temperature of the thermostat (Click here).
Reinstall the thermostat (Click here).
|
| ||||
| OK | ||
| ||