Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DIAGNOSIS SYSTEM


    F040034E32
  1. Inspect the battery voltage.

    Battery voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge the battery before proceeding.

  2. Check DLC3.
    The vehicle's tire pressure monitor ECU uses ISO 9141-2 for communication. The terminal arrangement of DLC3 complies with SAE J1962 and matches the ISO 9141-2 format.
    Verify the conditions listed in the table below:

    Terminal No.
    Disc.
    Connection / Voltage or Resistance
    Condition
    7
    SIL
    Bus + Line / Pulse generation
    During transmission
    4
    CG
    Chassis Ground to Body Ground / 1 Ω or less
    Always
    16
    BAT
    Battery Positive to Body Ground / 10 to 14 V
    Always

    HINT:
    If the intelligent tester display shows UNABLE TO CONNECT TO VEHICLE when the cable of the intelligent tester is connected to DLC3, the ignition switch is turned to the ON position and the tester is operated, there is a problem on the vehicle side or tester side.

    1. If communication is normal when the tester is connected to another vehicle, inspect DLC3 on the original vehicle.
    2. If communication is still not possible when the tool is connected to another vehicle, the problem is probably in the tester itself, so consult the Service Department listed in the tester's instruction manual.



  3. F045853E02
  4. Warning light.

    1. The tire pressure warning light blinks when there is any malfunction in the tire pressure warning system.

      NOTICE:
      When the malfunction has been corrected, the tire pressure warning light does not come on.

  5. DTCs (Normal mode).

    1. DTCs are memorized in the tire pressure monitor ECU and read by the blinks of the tire pressure warning light or using the intelligent tester (Click here).

  6. Test mode.

    1. By switching from normal mode into test mode (input signal check), you can inspect the tire pressure monitor receiver assembly, each tire pressure monitor valve sub-assembly and vehicle speed sensor (Click here).


CHECK WARNING LIGHT


    F045853E02
  1. Turn the ignition switch to the ON position.

  2. Check that the tire pressure warning light comes on for 3 sec.
    If the warning check result is not normal, proceed to the troubleshooting for the tire pressure warning light circuit.
    Trouble Area
    See procedure
    Tire pressure warning light circuit
    Click here


TIRE PRESSURE WARNING LIGHT CHART


Immediately after turning the IG ON
Always
Comes on for 3 sec.
Goes off
Comes on
Blinks (*1)
Blinks (*2)
Blinks (*3)
Output DTC
Normal
○
○





Low tire pressure
○

○




System fail
○


○



ECU Connector poorly connected
○

○




TC ground (There is no DTC)
○



○


TC ground (There is DTC)
○





○
Test mode
○




○



    F046782E01
  1. *1: Comes on and goes off repeatedly at 0.5 second intervals.



  2. F046784E01
  3. *2: Comes on and goes off repeatedly at 0.25 second intervals.



  4. F046783E01
  5. *3: Comes on and goes off repeatedly at 0.125 second intervals.