11301C
1.INSTALL FRONT CRANKSHAFT OIL SEAL
Apply MP grease to the lip of a new oil seal.
Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
Keep the lip free from foreign matter.
Do not tap the oil seal at an angle.
13471
2.INSTALL CRANKSHAFT PULLEY
15671
3.INSTALL OIL FILTER BRACKET
16206
4.CONNECT WATER BY-PASS PIPE SUB-ASSEMBLY
16400
5.INSTALL RADIATOR ASSEMBLY
Install the radiator (See page Engine / Hybrid System>1GR-FE COOLING>RADIATOR>INSTALLATION).