17650G
1.CHECK PURGE VSV
Connect the intelligent tester to the DLC3.
Remove the V-bank cover (See page Engine / Hybrid System>1GR-FE INTAKE / EXHAUST>INTAKE MANIFOLD>REMOVAL).
Disconnect the hose (connected to the canister) from the purge VSV.
Start the engine and turn the tester main switch on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for EVAP Control.
| Tester Operation | Specified Condition |
|---|---|
| EVAP VSV: OFF | Purge VSV has no suction |
| EVAP VSV: ON | Purge VSV has suction |
Connect the hose (connected to the canister) to the purge VSV.
Install the V-bank cover (See page Engine / Hybrid System>1GR-FE INTAKE / EXHAUST>INTAKE MANIFOLD>INSTALLATION).
2.INSPECT FUEL CUT-OFF RPM
Start and warm up the engine.
Open the throttle valve and keep the engine speed at 3000 rpm.
Use a sound scope to check for injector operating noise.
Check that when the accelerator pedal is released, injector operation noise stops momentarily and then resumes.
If the result is as not specified, check the injector, wiring and ECM.
3.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS
Check that there are no cracks, leaks or damage.
Detachment or other problems with the engine oil dipstick, filler cap, PCV hose and other components may cause the engine to run improperly.
Disconnection, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will allow air suction and cause an engine failure or engine failure malfunctions.
If the result is not as specified, replace parts as necessary.
4.CHECK HOSES AND CONNECTORS
Visually check for loose connections, sharp bends or damage.
5.CHECK FUEL TANK ASSEMBLY
Visually check for deformation, cracks or fuel leakage.