Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › INTAKE MANIFOLD › 2013.08–2014.08
RM1440E _51 Engine / Hybrid System _056128 1GR-FE INTAKE / EXHAUST _0273906 INTAKE MANIFOLD A

1GR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53298 3.REMOVE COOL AIR INTAKE DUCT (for 4WD with TOYOTA Parking Assist-sensor System)

Hide 52129B 4.REMOVE FRONT BUMPER LOWER COVER (w/o TOYOTA Parking Assist-sensor System)

Hide 52129B 5.REMOVE FRONT BUMPER LOWER COVER (w/ TOYOTA Parking Assist-sensor System)

Hide 52822 6.REMOVE AIR INTAKE DUCT LH (w/ TOYOTA Parking Assist-sensor System)

Hide 52821 7.REMOVE AIR INTAKE DUCT RH (w/ TOYOTA Parking Assist-sensor System)

Hide 51405A 8.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 11259 10.REMOVE V-BANK COVER

a.
A306027E02
3.042,0.583 2.74,0.583 true 1.083,0.594 1.021,0.594 1.021,0.594 0.938,0.802 false 3.104,0.51 3.271,0.677 0.167,0.167 10 false *1 1.115,0.5 1.281,0.667 0.167,0.167 10 false *2

Raise the front of the V-bank cover to detach the 2 pins. Then detach the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

Text in Illustration
*1 Pin
*2 V-bank Cover Hook


Hide 17881 11.REMOVE NO. 1 AIR CLEANER HOSE

a.
A221455

Disconnect the ventilation hose and vacuum hose.


b.

Detach the wire harness clamp.


c.

Remove the bolt and loosen the 2 hose clamps.


d.

Remove the No. 1 air cleaner hose.


Hide 17129 12.REMOVE INTAKE AIR SURGE TANK

a.
A221456

Disconnect the throttle body connector.


b.

Disconnect the No. 4 water by-pass hose.


c.

Disconnect the No. 5 water by-pass hose.


d.
A221457

Disconnect the No. 1 fuel vapor feed hose.


e.

Disconnect the No. 1 vacuum switching valve connector.


f.

Disconnect the No. 1 ventilation hose.


g.
A221464

Detach the 2 heater hose clamps.


h.
A221460

Remove the 2 bolts and throttle body bracket.


i.
A225628

Using a clip remover, detach the wire harness clamp.


j.
A221462

Remove the 2 bolts and No. 1 surge tank stay.


k.
A221463

Remove the 2 bolts and No. 2 surge tank stay.


l.
A221465

Remove the 2 nuts, 4 bolts and intake air surge tank.


m.

Remove the gasket.


Hide 23801P 13.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

Hide 23802B 14.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 23807 15.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 17111 16.REMOVE INTAKE MANIFOLD

a.
A221466

Remove the 4 nuts, 6 bolts, intake manifold and 2 gaskets.