89465
1.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
89465
2.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
17450B
3.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY
Install the exhaust pipe support.
Set 2 new gaskets to the front No. 2 exhaust pipe assembly.
Connect the front No. 2 exhaust pipe assembly to the exhaust pipe support and exhaust manifold.
Install 2 new nuts.
Connect the heated oxygen sensor connector.
17548
4.INSTALL EXHAUST PIPE STOPPER BRACKET (for 4WD)
Install the exhaust pipe stopper bracket with the 2 bolts.
17410
5.INSTALL FRONT EXHAUST PIPE ASSEMBLY
Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the front exhaust pipe assembly.
| *1 | Gasket |
| *2 | Wooden Block |
Be sure to install the gasket so that it faces the correct direction.
Do not reuse the gasket.
Do not damage the gasket.
When connecting the exhaust pipe assembly, do not push in the gasket with the exhaust pipe assembly.
Install a new gasket and the front exhaust pipe assembly to the exhaust manifold with 2 new nuts.
Connect the front exhaust pipe assembly to the front No. 2 exhaust pipe assembly with the 2 bolts.
Connect the heated oxygen sensor connector.
17420
6.INSTALL CENTER EXHAUST PIPE ASSEMBLY
Using a vernier caliper, measure the free length of the compression spring.
40 mm (1.57 in.)
If the free length is less than the minimum, replace the compression spring.
Install the 4 exhaust pipe supports.
Connect the center exhaust pipe to the 4 exhaust pipe supports.
Install the center exhaust pipe with the 2 compression springs and 2 bolts.
17430
7.INSTALL TAILPIPE ASSEMBLY
Install the exhaust pipe support.
Set a new gasket to the center exhaust pipe assembly.
Connect the tailpipe to the exhaust pipe support.
Install the 2 bolts.
8.INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
52185A
9.INSTALL REAR BUMPER SIDE BRACKET RH (w/o TOYOTA Parking Assist-sensor System)
Attach the guide and install the rear bumper side bracket RH with the 3 screws and clip.
| *1 | Guide |
52185A
10.INSTALL REAR BUMPER SIDE BRACKET RH (w/ TOYOTA Parking Assist-sensor System)
Attach the guide and install the rear bumper side bracket RH with the 3 screws and clip.
| *1 | Guide |
76625G
11.INSTALL REAR QUARTER PANEL MUDGUARD RH (w/o TOYOTA Parking Assist-sensor System)
Install the rear quarter panel mudguard RH with the 6 screws and 3 clips.
76625G
12.INSTALL REAR QUARTER PANEL MUDGUARD RH (w/ TOYOTA Parking Assist-sensor System)
Install the rear quarter panel mudguard RH with the 4 screws and 4 clips.
51450
13.INSTALL REAR ENGINE UNDER COVER ASSEMBLY