16711
1.REMOVE FAN SHROUD
Remove the fan shroud (See page Engine / Hybrid System>1GR-FE COOLING>WATER PUMP>REMOVAL).
16100
2.INSPECT WATER PUMP ASSEMBLY
Visually check the air hole and water hole for coolant leakage.
| *1 | Water Hole |
| *2 | Air Hole |
If leakage is found, replace the water pump assembly.
Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the water pump assembly.
16210
3.INSPECT FLUID COUPLING ASSEMBLY
Remove the 4 nuts and fan.
Check the fluid coupling for damage or silicon oil leaks.
If necessary, replace the fluid coupling.
Install the fan with the 4 nuts.
16711
4.INSTALL FAN SHROUD
Install the fan shroud (See page Engine / Hybrid System>1GR-FE COOLING>WATER PUMP>INSTALLATION).