Home › Engine / Hybrid System › 1GR-FE LUBRICATION › OIL PRESSURE SWITCH
RM1440E _51 Engine / Hybrid System _056130 1GR-FE LUBRICATION _0273916 OIL PRESSURE SWITCH A

1GR-FE LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Apply adhesive to 2 or 3 threads of the oil pressure switch.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the oil pressure switch.



b.

Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



c.

Connect the oil pressure switch connector.