Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB(for 2WD)
RM1440E _52 Drivetrain _056137 AXLE AND DIFFERENTIAL _0273967 FRONT AXLE HUB(for 2WD) A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB(for 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43502C 1.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

a.

Apply MP grease to a new O-ring.


b.

Install the O-ring to the axle hub.

NOTICE:

Do not damage the O-ring.



c.

Install the disc brake dust cover and axle hub to the steering knuckle with the 4 bolts.

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)


Hide 47750 3.INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

Hide 4.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 5.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

a.

Inspect and adjust the front wheel alignment (See page Suspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT).


Hide 6.CHECK SPEED SENSOR SIGNAL