Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0273995 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

The procedure listed below is for the LH side.

·

Other than areas where instructions are provided, use the same procedures for the RH side and LH sides.



PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR

a.

Using a 5 mm hexagon wrench, install the speed sensor with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

·

While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

·

After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

·

Make sure there is no foreign matter attached to the speed sensor rotor.




Hide 2.INSTALL SKID CONTROL SENSOR CLAMP

a.

Install the skid control sensor clamp with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:

Install the clamp so that the rotation stopper touches the knuckle.



Hide 89516 3.INSTALL FRONT SKID CONTROL SENSOR WIRE

a.

Connect the connector as follows.

i.

for LH:

1. Attach the connector, and then connect the connector.

NOTICE:

Securely connect the connector.



ii.

for RH:

1. Install the skid control sensor clamp with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)

NOTICE:

Make sure the clamp rotation stopper touches the installation position.


2. Attach the connector, and then connect the connector.

NOTICE:
·

Securely connect the connector.

·

When connecting the connector, do not twist the wire harness.



3. Attach the clip.



b.

Install the 2 harness clamps with the 2 bolts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:
·

When installing the clamps, do not twist the wire harness.

·

Make sure the clamp rotation stopper touches the installation position.




c.

Install the 2 harness clamps with the 2 bolts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:
·

When installing the clamps, do not twist the wire harness.

·

Make sure the clamp rotation stopper touches the installation position.




d.

Attach the clip.


e.

Connect the connector.

NOTICE:

Securely connect the connector.



Hide 89543 5.CHECK SPEED SENSOR SIGNAL