Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB(for 4WD)
RM1440E _52 Drivetrain _056137 AXLE AND DIFFERENTIAL _0273968 FRONT AXLE HUB(for 4WD) A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB(for 4WD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43502C 1.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

a.

Apply MP grease to a new O-ring.


b.

Install the O-ring to the axle hub.


c.

Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)


Hide 43502H 2.INSTALL FRONT AXLE SHAFT NUT

a.

Clean the threaded parts on the drive shaft and axle shaft nut using a non-residue solvent.


b.

Install the front axle shaft nut.

Torque:
235 N*m (2396 kgf*cm, 173 ft.*lbf)


c.

Install the adjusting cap and cotter pin.


Hide 43514C 3.INSTALL FRONT AXLE HUB GREASE CAP

a.

Install a new axle hub grease cap.

NOTICE:

Make sure the grease cap is securely installed to the axle hub.



Hide 47750 5.INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

Hide 6.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 7.ADJUST FRONT WHEEL ALIGNMENT

a.

Hide 8.CHECK SPEED SENSOR SIGNAL