Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM1440E _53 Suspension _056139 FRONT SUSPENSION _0273984 FRONT LOWER SUSPENSION ARM A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48069 1.TEMPORARILY INSTALL FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH

a.
G020160E14
0.99,0.99 1.49,1.865 1.49,1.865 2.531,0.635 false 1.417,1.885 1.625,2.063 0.208,0.177 10 false *a

Temporarily install the lower suspension arm, camber adjust cam, No. 2 camber adjust cam, No. 2 toe adjust plate and toe adjust cam with the bolt and nut.

Text in Illustration
*a Matchmark


b.

Align the matchmarks on the No. 2 camber adjust cam and toe adjust cam sub-assembly with the matchmarks on the vehicle body. Tighten the bolt and nut.


c.

Install the front lower ball joint attachment LH with a new nut and cotter pin.

Torque:
140 N*m (1428 kgf*cm, 103 ft.*lbf)


d.

Connect the front lower ball joint attachment LH to the steering knuckle with the 2 bolts.

Torque:
160 N*m (1632 kgf*cm, 118 ft.*lbf)


Hide 2.TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING

a.

Temporarily install the front shock absorber with coil spring and washer with the bolt and nut.


Hide 3.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 48069 5.TIGHTEN FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH

a.
G020160

Tighten the bolt and nut.

Torque:
175 N*m (1785 kgf*cm, 129 ft.*lbf)


Hide 6.TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING

a.

Tighten the nut.

Torque:
95 N*m (969 kgf*cm, 70 ft.*lbf)


Hide 7.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

a.

Inspect and adjust the front wheel alignment (See page Suspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT).