Home › Suspension › REAR SUSPENSION › REAR COIL SPRING
RM1440E _53 Suspension _056140 REAR SUSPENSION _0273988 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 48302 1.INSTALL HOLLOW SPRING SUB-ASSEMBLY

a.

Install the hollow spring to the frame.


Hide 48231B 2.INSTALL REAR COIL SPRING LH

a.
D028471

Install the rear coil spring to the rear axle housing.

HINT:

Before installing the coil spring, check that the coil spring end is in the correct position. If not, reinstall the coil spring.



Hide 48540 3.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

a.

Temporarily install the lower side of the shock absorber with the bolt.


Hide 48540 5.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the bolt.

Torque:
98 N*m (999 kgf*cm, 72 ft.*lbf)


Hide 47319F 6.CONNECT REAR FLEXIBLE HOSE

Hide 10.CHECK FOR BRAKE FLUID LEAK

Hide 11.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)