Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0273996 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 89516B 1.INSTALL SKID CONTROL SENSOR WIRE

a.

Install the 2 sensor clamps with the 2 bolts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:

Make sure the clamp rotation stopper touches the installation position.



b.

Connect the connector.

NOTICE:

Securely connect the connector.



c.

Attach the connector.


d.

Attach the 8 clamps.

NOTICE:

When attaching the clamps, do not twist the wire harness.



Hide 89546 2.INSTALL REAR SPEED SENSOR LH

a.

Install the speed sensor with the nut.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)

NOTICE:
·

Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

·

While inserting the speed sensor into the axle hole, do not strike or damage the sensor tip.

·

After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle.

·

Make sure there is no foreign matter attached to the speed sensor rotor.




b.

Connect the speed sensor connector.

NOTICE:

Securely connect the connector.



Hide 89545 3.INSTALL REAR SPEED SENSOR RH

HINT:

Use the same procedure described for the LH side.


Hide 89546 5.CHECK SPEED SENSOR SIGNAL