Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND ACCELERATION SENSOR
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0273997 YAW RATE AND ACCELERATION SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND ACCELERATION SENSOR  INSTALLATION  


PROCEDURE

Hide 89183A 1.INSTALL YAW RATE AND ACCELERATION SENSOR

a.

Connect the connector, and then attach the clamp to the hole of the sensor bracket.

NOTICE:

Securely connect the connector.



b.

Install the yaw rate and acceleration sensor with the 2 bolts.

Torque:
15 N*m (148 kgf*cm, 11 ft.*lbf)

NOTICE:
·

If the sensor is dropped, replace it.

·

Make sure the bracket rotation stopper touches the installation position.

·

Make sure that the sensor is oriented correctly.

·

When installing the sensor, make sure to avoid impacts to the sensor.




Hide 58901A 2.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

a.

Install the rear console box sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>INSTALLATION).


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 89183A 4.PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

a.

Perform yaw rate and acceleration sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


Hide 89183A 5.CHECK YAW RATE AND ACCELERATION SENSOR SIGNAL

a.