Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND ACCELERATION SENSOR
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0273997 YAW RATE AND ACCELERATION SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND ACCELERATION SENSOR  REMOVAL  


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 58901A 2.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

a.

Remove the rear console box sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL).


Hide 89183A 3.REMOVE YAW RATE AND ACCELERATION SENSOR

a.
C212848

Remove the 2 bolts and yaw rate and acceleration sensor.


b.

Disconnect the connector, and then detach the clamp from the sensor bracket.