Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER › 2009.08–2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0273999 SKID CONTROL BUZZER A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  SKID CONTROL BUZZER  INSTALLATION  


PROCEDURE

Hide 86652A 1.INSTALL SKID CONTROL BUZZER ASSEMBLY

a.

Connect the connector.

NOTICE:

Securely connect the connector.



b.

Attach the clamp to install the buzzer.

NOTICE:
·

Securely insert the clamp into the dash panel.

·

If the buzzer is dropped, replace it.




Hide 2.INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

a.

Install the instrument panel safety pad sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).


Hide 28800 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).