Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER › 2009.08–2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0273999 SKID CONTROL BUZZER A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  SKID CONTROL BUZZER  REMOVAL  


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

a.

Remove the instrument panel safety pad sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).


Hide 86652A 3.REMOVE SKID CONTROL BUZZER ASSEMBLY

a.
C212851

Detach the clamp and remove the buzzer.


b.

Disconnect the connector.