Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274004 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  43  ABS Control System Malfunction  


DESCRIPTION

This DTC is output when the VSC system detects a malfunction in the ABS.

DTC Code DTC Detection Condition Trouble Area
43 A malfunction in the anti-lock brake system. Anti-lock brake system

CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK ANTI-LOCK BRAKE SYSTEM

b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON.


d.

Check if an ABS DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC (ABS DTC) is not output A
DTC (ABS DTC) is output B



A

2.CONFIRM DTC

B

2.CONFIRM DTC

b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON.


d.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

B

REPLACE MASTER CYLINDER SOLENOID