Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2009.08–2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274004 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1337  Diameter of the Tire is not Uniform  


DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must indicate the same speed.

DTC Code DTC Detection Condition Trouble Area
C1337 Either condition is met:
·

The diameter of 2 front wheels and 2 rear wheels is different.

·

There is a wheel speed sensor fault.


·

Speed sensor

·

Speed sensor rotor

·

Speed sensor circuit

·

Tire size



CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


HINT:

When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).


PROCEDURE

1.CHECK TIRE SIZE
a.

Check tire size and condition of all 4 wheels.

OK:

Condition of all 4 wheels is normal and tire size is same.




OK

2.RECONFIRM DTC

NG

REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME SIZE

2.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.


d.

Check if the same DTCs are output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

HINT:

Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.


Result
Result Proceed to
DTC is output A
DTC is not output B



A

REPLACE MASTER CYLINDER SOLENOID

B