Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274004 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1257  Power Supply Drive Circuit  


DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.

DTC Code DTC Detection Condition Trouble Area
C1257 There is an open in the motor system circuit (motor input circuit). Master cylinder solenoid (Skid control ECU)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK PUMP MOTOR OPERATION
a.

Turn the ignition switch off.


b.

Disconnect the A6 skid control ECU connector.


c.

Depress the brake pedal more than 40 times.


d.

Turn the ignition switch to ON.


e.

Check pump motor operation.

OK:

Pump motor operates normally.




OK

2.RECONFIRM DTC

NG

REPLACE MASTER CYLINDER SOLENOID

2.RECONFIRM DTC
a.

Turn the ignition switch off.


b.

Reconnect the A6 skid control ECU connector.


c.

Turn the ignition switch to ON.



e.

Turn the ignition switch off.


f.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

REPLACE MASTER CYLINDER SOLENOID

B