Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274004 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1452  Accumulator Low Pressure  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
C1452 After braking, the fluid pressure inside the accumulator is below the threshold within 3.2 seconds.
·

Hydraulic circuit

·

Master cylinder solenoid (Accumulator pressure sensor)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CUSTOMER PROBLEM ANALYSIS
a.

Check with the customer to determine if frequent braking has been performed.



NEXT

2.RECONFIRM DTC
2.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Depress the brake pedal more than 40 times.


d.

Turn the ignition switch to ON.


e.

Wait for 99 seconds.


f.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
Frequent braking was not performed and DTC is not output B
Frequent braking was performed and DTC is not output C

HINT:

Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.




A

3.CHECK HYDRAULIC CIRCUIT

B

C

END

3.CHECK HYDRAULIC CIRCUIT
a.

Check the hydraulic circuit (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE LINE>SYSTEM DIAGRAM).

OK:

Hydraulic circuit is normal (no leakage).




OK

4.READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR)

NG

REPAIR HYDRAULIC CIRCUIT

4.READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR)

OK

5.RECONFIRM DTC

NG

REPLACE MASTER CYLINDER SOLENOID