Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL
RM1440E _54 Brake _056143 BRAKE SYSTEM (OTHER) _0274007 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55045 2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

a.

Remove the lower instrument panel finish panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).


Hide 47101A 3.REMOVE BRAKE PEDAL RETURN SPRING

Hide 47264A 4.REMOVE PUSH ROD PIN

a.

Remove the clip and push rod pin from the brake pedal lever.


Hide 84340 5.REMOVE STOP LIGHT SWITCH ASSEMBLY

a.

Disconnect the stop light switch connector.


b.

Remove the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL).


Hide 55106 6.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.

Remove the brake pedal support reinforcement set bolt.


b.

Remove the hydraulic brake booster assembly (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER>REMOVAL).


c.
C214646

Remove the brake pedal support assembly.