Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE
RM1440E _54 Brake _056146 PARKING BRAKE _0274015 PARKING BRAKE CABLE A

PARKING BRAKE  PARKING BRAKE CABLE  INSTALLATION  


PROCEDURE

Hide 46420 1.INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY

a.

Attach the claws of the No. 2 parking brake cable.


b.

Install the No. 2 parking brake cable assembly to the parking brake equalizer with the clip.


c.

Install the No. 2 parking brake cable assembly with the 5 bolts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


d.

Install the No. 1 parking brake cable heat insulator.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


e.

Install the parking brake cable assembly No. 2 to the backing plate with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 46430 2.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Attach the claws of the No. 3 parking brake cable.


b.

Install the No. 3 parking brake cable assembly to the parking brake equalizer with the clip.


c.

Connect the No. 3 parking brake cable clamp to the No. 3 parking brake cable.


d.

Install the No. 3 parking brake cable assembly with the 4 bolts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


e.

Install the No. 3 parking brake cable assembly to the backing plate with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 46590 3.INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY WHITH PARKING BRAKE SHOE LEVER

HINT:

HINT: Refer to the procedures from "Install No. 2 Parking Brake Shoe Assembly with Parking Brake Shoe Lever" (See page Brake>PARKING BRAKE>PARKING BRAKE ASSEMBLY>REASSEMBLY).


Hide 77100U 4.INSTALL FUEL TANK SUB-ASSEMBLY

a.

Install the fuel tank sub-assembly (See page Engine / Hybrid System>1GR-FE FUEL>FUEL TANK>INSTALLATION).


Hide 5.ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL

Hide 58910C 6.INSTALL REAR CONSOLE BOX ASSEMBLY

a.

Install the rear console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>INSTALLATION).


Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).