Home › Steering › STEERING COLUMN › STEERING WHEEL › from 2013.08
RM1440E _55 Steering _056148 STEERING COLUMN _0274024 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


PROCEDURE

Hide 45100 1.INSTALL STEERING WHEEL ASSEMBLY

a.

Align the matchmarks on the steering wheel assembly and steering main shaft assembly.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 45116 3.INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

a.

Attach the claw and 2 guides to install the No. 1 steering wheel ornament.


b.

Install the 2 screws.

Torque:
2.4 N*m (24 kgf*cm, 21 in.*lbf)


Hide 45117 4.INSTALL NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

a.

Attach the claw and 2 guides to install the No. 2 steering wheel ornament.


b.

Install the 2 screws.

Torque:
2.4 N*m (24 kgf*cm, 21 in.*lbf)


Hide 84250A 5.INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)

a.

Attach the 2 claws and 4 guides to install the steering pad switch assembly.


b.

Install the 4 screws.

Torque:
2.4 N*m (24 kgf*cm, 21 in.*lbf)


c.

Connect the connector.


Hide 45186 7.INSTALL NO. 2 STEERING WHEEL LOWER COVER

Hide 45187 8.INSTALL NO. 3 STEERING WHEEL LOWER COVER

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).