Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering wheel (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45187
3.REMOVE NO. 3 STEERING WHEEL LOWER COVER
45186
4.REMOVE NO. 2 STEERING WHEEL LOWER COVER
45130
5.REMOVE STEERING PAD
45116
6.REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Remove the 2 bolts.
Detach the claw and 2 guides to remove the No. 1 steering wheel ornament.
45117
7.REMOVE NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Remove the 2 bolts.
Detach the claw and 2 guides to remove the No. 2 steering wheel ornament.
Refer to "Remove No. 1 Steering Wheel Ornament".
84250A
8.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
Disconnect the connector.
Remove the 4 screws.
Detach the 2 claws and 4 guides to remove the steering pad switch assembly.
84632
9.REMOVE CRUISE CONTROL MAIN SWITCH
45100
10.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel set nut.
Put matchmarks on the steering wheel and main shaft.
| *a | Matchmark |
| *b | Hold |
| *c | Turn |
Using SST, remove the steering wheel assembly.