Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2009.08–2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch to the radio receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch.

If there is a short in the circuit, the same condition as when the switch is continuously depressed occurs.

Therefore, the radio receiver assembly cannot be operated using the steering pad switch, and the radio receiver assembly itself cannot function.

WIRING DIAGRAM

E195971E24
2.49,1.052 2.969,1.26 0.479,0.208 10 false Seek+ 1.771,1.052 2.229,1.26 0.458,0.208 10 false Seek- 1,1.031 1.594,1.354 0.594,0.323 10 false Volume+ 0.323,1.01 0.885,1.313 0.563,0.302 10 false Volume- 1.823,3.438 2.24,3.792 0.417,0.354 10 false On Hook 2.448,1.771 2.927,2.031 0.479,0.26 10 false MODE 2.448,3.438 2.906,3.792 0.458,0.354 10 false Off Hook 3.229,3.438 3.635,3.667 0.406,0.229 10 false Voice 1.313,4.885 3.375,5.104 2.063,0.219 10 false Steering Pad Switch Assembly 1.292,4.375 3.479,4.594 2.188,0.219 10 false Steering Pad Switch Assembly RH 1.313,2.573 3.5,2.792 2.188,0.219 10 false Steering Pad Switch Assembly LH 4.438,2.167 4.792,2.375 0.354,0.208 10 false z11 4.438,1.49 4.792,1.698 0.354,0.208 10 false z11 4.438,0.781 4.792,0.99 0.354,0.208 10 false z11 5.448,2.177 5.771,2.344 0.323,0.167 10 false F23 5.458,1.49 5.781,1.656 0.323,0.167 10 false F23 5.458,0.771 5.781,0.938 0.323,0.167 10 false F23 4.458,0.552 4.667,0.75 0.208,0.198 10 false 10 4.5,1.271 4.615,1.427 0.115,0.156 10 false 8 4.51,1.958 4.656,2.135 0.146,0.177 10 false 9 4.906,1.458 5.219,1.635 0.313,0.177 10 false EAU 4.927,2.135 5.219,2.313 0.292,0.177 10 false AU2 4.906,0.781 5.198,0.958 0.292,0.177 10 false AU1 5.521,0.5 5.615,0.667 0.094,0.167 10 false 6 5.521,1.219 5.635,1.417 0.115,0.198 10 false 4 5.521,1.906 5.667,2.063 0.146,0.156 10 false 5 4.667,2.594 5.604,2.979 0.938,0.385 10 false Spiral Cable Sub-assembly 6.063,0.615 6.208,0.781 0.146,0.167 10 false 7 6.073,1.323 6.302,1.479 0.229,0.156 10 false 6 6.073,2.01 6.208,2.188 0.135,0.177 10 false 8 6.26,2.177 6.76,2.354 0.5,0.177 10 false SW2 6.271,1.521 6.771,1.698 0.5,0.177 10 false SWG 6.271,0.771 6.771,0.948 0.5,0.177 10 false SW1 6.135,2.656 6.365,2.813 0.229,0.156 10 false G9 6.125,2.802 7.115,3.177 0.99,0.375 10 false Radio Receiver Assembly

CAUTION / NOTICE / HINT

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the Precaution in the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).

E353105E01
4.542,0.938 4.927,0.802 4.927,0.802 5.25,0.802 true 4.417,0.99 4.76,1.219 4.76,1.219 5.365,1.219 true 4.323,1 4.604,1.333 4.604,1.333 4.844,1.333 true 4.927,1.719 5.5,2.052 5.5,2.052 5.781,2.052 true 4.708,1.719 5.24,2.406 5.24,2.406 5.448,2.406 true 4.677,1.938 5.344,2.958 5.344,2.958 5.552,2.958 true 1.708,0.729 1.979,0.729 1.979,0.729 2.458,1.708 true 1.333,1.188 1.583,1.188 1.583,1.188 2.25,1.719 true 1.052,1.573 1.26,1.573 1.26,1.573 2.26,1.844 true 1.271,2.198 1.51,2.198 1.51,2.198 2.479,1.844 true 1.542,2.552 1.771,2.552 1.771,2.552 2.344,2.021 true 5.323,0.708 5.656,0.938 0.333,0.229 10 false AU1 5.438,1.115 5.771,1.344 0.333,0.229 10 false AU2 4.906,1.271 5.24,1.5 0.333,0.229 10 false EAU 5.865,1.979 6.948,2.167 1.083,0.188 10 false Off Hook Switch 5.531,2.323 6.615,2.51 1.083,0.188 10 false On Hook Switch 5.635,2.885 6.49,3.083 0.854,0.198 10 false Voice Switch 0.615,0.615 1.677,0.833 1.063,0.219 10 false Volume+ Switch 0.313,1.083 1.375,1.302 1.063,0.219 10 false Volume- Switch 0.156,1.5 1.219,1.719 1.063,0.219 10 false Seek- Switch 0.385,2.125 1.448,2.344 1.063,0.219 10 false Seek+ Switch 0.667,2.469 1.729,2.688 1.063,0.219 10 false Mode Switch


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
10 (AU1) - 8 (EAU) No switch is pushed 95 to 105 kΩ
Seek+ switch is pushed Below 2.5 Ω
Seek- switch is pushed 313 to 345 Ω
Volume+ switch is pushed 950 to 1050 Ω
Volume- switch is pushed 2955 to 3265 Ω
9 (AU2) - 8 (EAU) No switch is pushed 95 to 105 kΩ
MODE switch is pushed Below 2.5 Ω
On hook switch is pushed 313 to 345 Ω
Off hook switch is pushed 950 to 1050 Ω
Voice switch is pushed 2955 to 3265 Ω




OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY
a.

Remove the spiral cable sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).

E353054E01
2.479,1.042 2.563,0.76 true 2.74,1.125 2.656,0.76 true 3.083,1.125 2.771,0.76 true 4.333,2.948 4.563,2.469 true 4.646,3.083 4.646,2.469 true 5.063,3.01 4.729,2.448 true 1.865,0.292 2.063,0.49 0.198,0.198 10 false *a 2.167,0.958 2.469,1.156 0.302,0.198 10 false AU1 3.115,1.063 3.417,1.26 0.302,0.198 10 false EAU 2.688,1.115 2.99,1.313 0.302,0.198 10 false AU2 3.656,1.802 3.854,2 0.198,0.198 10 false *b 5.073,3.031 5.375,3.229 0.302,0.198 10 false AU1 4.552,3.104 4.854,3.302 0.302,0.198 10 false AU2 4.167,2.969 4.469,3.167 0.302,0.198 10 false EAU


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
8 (EAU) - 4 (EAU) Spiral cable is turned 2.5 rotations counterclockwise Below 1 Ω
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise
10 (AU1) - 6 (AU1) Spiral cable is turned 2.5 rotations counterclockwise
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise
9 (AU2) - 5 (AU2) Spiral cable is turned 2.5 rotations counterclockwise
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise


Text in Illustration
*a Steering Pad Switch Assembly Side
*b Vehicle Side

CAUTION:

The spiral cable is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable may prevent the airbag from deploying. Be sure to read the Precaution in the SRS (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).




OK

3.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - SPIRAL CABLE)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - SPIRAL CABLE)
a.

Disconnect the G9 radio receiver assembly connector.


b.

Disconnect the F23 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G9-7 (SW1) - F23-6 (AU1) Always Below 1 Ω
G9-8 (SW2) - F23-5 (AU2) Always Below 1 Ω
G9-6 (SWG) - F23-4 (EAU) Always Below 1 Ω
G9-7 (SW1) - Body ground Always 10 kΩ or higher
G9-8 (SW2) - Body ground Always 10 kΩ or higher
G9-6 (SWG) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR