Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › from 2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Display does not Dim when Light Control Switch is Turned ON  


PROCEDURE

1.CHECK IMAGE QUALITY SETTING
a.

Turn the light control switch to the tail or head position.


b.

Check that the daytime screen setting on the display adjustment screen is set to on.

Result:
Result Proceed to
Daytime screen setting is set to on. A
Daytime screen setting is set to off. B




A

CHANGE DAYTIME SCREEN SETTING TO OFF

B

2.CHECK VEHICLE SIGNAL (OPERATION CHECK)
2.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
E225854

Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK).


b.

Check that the display changes between ON and OFF according to the light control switch operation.

OK:
Light Control Switch Display
Tail or head ON
Off OFF


HINT:

The display is updated once per second. It is normal for the display to lag behind the actual switch operation.




OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE