| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| 01-D6*1 | Either condition is met:
·
The device that stores (stored) the code has (had) been disconnected when the ignition switch is ACC or ON. ·
The master device has (had) been disconnected when this code is stored. |
·
Radio receiver power source circuit ·
Power source circuit of the component which has stored this code ·
AVC-LAN circuit between the radio receiver assembly and the component which has stored this code ·
Component which has stored this code ·
Radio receiver assembly |
| 01-D7*2 | Either condition is met:
·
The device that stored the code has (had) been disconnected after the engine starts (started). ·
The master device has (had) been disconnected when this code is (was) stored. |
*1: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.
*2: When 210 seconds have elapsed after disconnecting the power supply connector of the master unit with the ignition switch in ACC or ON, this code is stored.
Before starting troubleshooting, be sure to clear DTCs to clear codes stored due to the reasons described in Hint above. Then, check for DTCs and troubleshoot according to the output DTCs.
The radio receiver assembly is the master unit.
Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.
Be sure to read Description before performing the following procedures.
Refer to Radio Receiver Power Source Circuit (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>Radio Receiver Power Source Circuit).
If the power source circuit is operating normally, proceed to the next step.
NEXT
Enter the diagnostic mode.
Press the preset switch "channel 3" to change to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical Address |
|---|---|
| Radio receiver assembly | 190 |
| Multi-media interface ECU | 388 |
"440 (stereo component amplifier assembly)" is the component which has stored this code in the example shown in the illustration.
For details of the DTC display, refer to DTC Check/Clear (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
NEXT
Inspect the power source circuit of the component which has stored this code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
|---|---|
| Radio receiver assembly | Radio Receiver Power Source Circuit (See page ( ))
|
| Multi-media interface ECU | Multi-media Interface ECU Power Source Circuit (See page ( ))
|
NEXT
Disconnect the G8 radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G8-9 (TXM+) - G8-10 (TXM-) | Always | 60 to 80 Ω |
OK
NG
For details of the connectors, refer to Terminals of ECU (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>TERMINALS OF ECU).
Referring to the wiring diagram, check the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
Disconnect all connectors between the radio receiver assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
There is no open or short circuit.
OK
NG
Replace the component which has stored this code with a normal one and check if the same problem occurs again.
Same problem does not occur.
OK
NG