| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| 01-DF* | Either condition is met:
·
The device with a display fails and the master is switched to the audio device. ·
A communication error between the sub-master (audio) and master occurs. |
·
Radio receiver power source circuit ·
AVC-LAN circuit between the radio receiver assembly and the component which has stored this code ·
Radio receiver assembly ·
Component which has stored this code |
*: When 210 seconds have elapsed after disconnecting the power supply connector of the master unit with the ignition switch ACC or ON, this code is stored.
Before starting troubleshooting, be sure to clear DTCs to clear codes stored due to the reasons described in Hint above. Then, check for DTCs and troubleshoot according to the output DTCs.
The radio receiver assembly is the master unit.
Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.
Be sure to read Description before performing the following procedures.
Refer to Radio Receiver Power Source Circuit (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>Radio Receiver Power Source Circuit).
If the power source circuit is operating normally, proceed to the next step.
NEXT
Disconnect the G8 radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G8-9 (TXM+) - G8-10 (TXM-) | Always | 60 to 80 Ω |
OK
NG
Enter the diagnostic mode.
Press the preset switch "channel 3" to change to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical Address |
|---|---|
| Radio receiver assembly | 190 |
| Multi-media interface ECU | 388 |
"440 (stereo component amplifier)" is the component which has stored this code in the example shown in the illustration.
For details of the DTC display, refer to DTC Check/Clear (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
NEXT
For details of connectors, refer to Terminals of ECU (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>TERMINALS OF ECU).
Referring to the AVC-LAN wiring diagram, check the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
Disconnect all connectors between the radio receiver assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
There is no open or short circuit.
OK
NG
Replace the radio receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL).
Same problem does not occur.
OK
NG