89348
1.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
Align the keyhole and protrusion as shown in the illustration.
| *a | Keyhole |
Attach the 4 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper cover.
Do not damage the bumper cover with the protrusion when installing the No. 1 ultrasonic sensor retainer.
Use the same procedure as for the other side.
89348A
2.INSTALL NO. 2 ULTRASONIC SENSOR RETAINER
Align the keyhole and protrusion as shown in the illustration.
| *1 | Keyhole |
Attach the 3 claws to install the No. 2 ultrasonic sensor retainer to the rear bumper cover.
Do not damage the bumper cover with the protrusion when installing the No. 2 ultrasonic sensor retainer.
Use the same procedure as for the other side.
89348D
3.INSTALL ULTRASONIC SENSOR CLIP
Attach the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor.
Use the same procedure as for the other side.
89341A
4.INSTALL NO. 1 ULTRASONIC SENSOR
Attach the 2 claws to install the No. 1 ultrasonic sensor to the ultrasonic sensor retainer.
Use the same procedure as for the other side.
82163
5.INSTALL NO. 3 FLOOR WIRE
52159
6.INSTALL REAR BUMPER COVER
76626E
7.INSTALL REAR QUARTER PANEL MUDGUARD LH
76625G
8.INSTALL REAR QUARTER PANEL MUDGUARD RH
Use the same procedure as for the LH side.
58766A
9.INSTALL JACK BOX HOLE COVER