Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2013.08
RM1440E _57 Power Source / Network _056154 NETWORKING _0274053 CAN COMMUNICATION SYSTEM S

NETWORKING  CAN COMMUNICATION SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of code, refer to the "See page" below.


CAN Communication System
DTC Code Detection Item Trouble Area DTC Output from See page
U0208 Lost Communication with "Seat Control Module A" - Power source or inside front power seat switch LH
- Front power seat switch LH branch wire or connector
- Front power seat switch LH
Main body ECU (multiplex network body ECU) (Click here)
U1002 Lost Communication with Gateway Module (MS Bus) - MS bus circuit
- Front power seat switch LH branch wire or connector
- Main body ECU (multiplex network body ECU) main wire or connector
- Combination meter assembly main wire or connector
- Main body ECU (multiplex network body ECU)
- Combination meter assembly
- Front power seat switch LH
- No. 2 junction connector
Main body ECU (multiplex network body ECU) (Click here)