Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK
RM1440E _58 Vehicle Interior _056155 DOOR LOCK _0274059 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 69760C 1.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 69720B 2.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 69040A 3.INSTALL FRONT DOOR LOCK ASSEMBLY LH

NOTICE:
·

When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water to enter into the connection. This may result in a malfunction of the front door lock assembly.



B239752

a.

Apply MP grease to the sliding parts of the front door lock assembly.


b.

Install a new door lock wiring harness seal to the front door lock assembly.


c.

Insert the front door lock open rod into the front door lock assembly.


d.

Check that the front door lock open rod is securely connected to the front door lock assembly.


e.

Using a T30 "TORX" wrench, install the front door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

Connect the connector.


Hide 69217F 4.INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH

Hide 67404F 5.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 68151E 6.INSTALL FRONT DOOR GLASS RUN LH

Hide 68102 7.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 67832 8.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 68172A 9.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

Hide 67602 10.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 69298A 11.INSTALL DOOR NO. 2 INSIDE HANDLE BEZEL LH

Hide 67492A 12.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 14.CHECK SRS WARNING LIGHT