The key reminder warning buzzer sounds when the driver side door is opened while the ignition switch is ACC or off and the key is in the ignition key cylinder. The key reminder warning buzzer is activated when the main body ECU (multiplex network body ECU) sends an unlock warning switch signal and front door courtesy light switch LH signal to the combination meter.
Since the key reminder warning system has functions that use CAN communication, first confirm that there is no malfunction in the communication system by inspecting CAN communication in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.
Check the Data List for proper functioning of the front door courtesy light switch (See page Vehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| FL Door Courtesy | Front door courtesy light switch LH signal / ON or OFF | ON: Front door LH closed
OFF: Front door LH open |
- |
On tester screen, item changes between ON and OFF according to above chart.
OK
NG
Check the Data List for proper functioning of the unlock warning switch (See page Vehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Key Unlock Warning SW | Unlock warning switch signal / ON or OFF | ON: Key in ignition key cylinder
OFF: No key in ignition key cylinder |
- |
On tester screen, item changes between ON and OFF according to above chart.
OK
NG
Remove the unlock warning switch (See page Vehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (UN+) - 2 (UN-) | Not pushed | 10 kΩ or higher |
| Pushed | Below 1 Ω |
OK
NG
Disconnect the F18 unlock warning switch connector.
Disconnect the F9 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F18-1 (UN+) - F9-17 (KSW) | Always | Below 1 Ω |
| F18-2 (UN-) - Body ground | Always | Below 1 Ω |
| F9-17 (KSW) - Body ground | Always | 10 kΩ or higher |
OK
NG
Temporarily replace the combination meter assembly with a new or normally functioning one (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
Check the key reminder warning system (See page Vehicle Interior>DOOR LOCK>KEY REMINDER WARNING SYSTEM>OPERATION CHECK).
The key reminder warning system functions properly.
OK
NG