Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM
RM1440E _58 Vehicle Interior _056156 THEFT DETERRENT / KEYLESS ENTRY _0274066 ENGINE IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  B2796  No Communication in Immobiliser System  B2798  Communication Malfunction No. 2  


DESCRIPTION

DTC B2796 is stored when a key is inserted into the ignition key cylinder but no communication occurs between the key and transponder key ECU assembly.

DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.


DTC Code DTC Detection Condition Trouble Area
B2796 The key code cannot be transmitted.
·

Key

·

Harness or connector

·

Transponder key ECU assembly

·

Transponder key amplifier


B2798 Key code identification cannot be completed within the specified time. Key

WIRING DIAGRAM

B235864E06
1.063,3.333 2.865,3.563 1.802,0.229 10 false Transponder Key Amplifier 0.656,1.594 1.479,1.75 0.823,0.156 10 false Antenna Coil 4.385,3.281 6.635,3.51 2.25,0.229 10 false Transponder Key ECU Assembly 5.177,0.521 5.521,0.698 0.344,0.177 10 false VC5 5.177,1.229 5.667,1.406 0.49,0.177 10 false CODE 5.177,1.948 5.688,2.125 0.51,0.177 10 false TXCT 5.177,2.656 5.677,2.833 0.5,0.177 10 false AGND 2.719,0.417 3.063,0.594 0.344,0.177 10 false VC5 1.604,0.385 2.01,0.563 0.406,0.177 10 false ANT2 1.604,2.76 2.01,2.938 0.406,0.177 10 false ANT1 2.594,1.104 3.083,1.281 0.49,0.177 10 false CODE 2.594,2.552 3.094,2.729 0.5,0.177 10 false AGND 4.885,0.417 5.24,0.75 0.354,0.333 10 false 14 4.896,1.115 5.208,1.354 0.313,0.24 10 false 15 4.969,1.823 5.323,2.156 0.354,0.333 10 false 4 4.969,2.521 5.323,2.854 0.354,0.333 10 false 5 3.063,0.417 3.417,0.75 0.354,0.333 10 false 1 3.073,1.104 3.385,1.344 0.313,0.24 10 false 4 3.063,1.833 3.417,2.167 0.354,0.333 10 false 5 3.073,2.542 3.427,2.875 0.354,0.333 10 false 7 2.615,1.833 3.125,2.01 0.51,0.177 10 false TXCT 4.385,3.115 4.813,3.292 0.427,0.177 10 false F34 1.073,3.167 1.5,3.344 0.427,0.177 10 false F17

CAUTION / NOTICE / HINT

NOTICE:

When replacing the transponder key ECU assembly or key, refer to the Service Bulletin.


PROCEDURE

1.CLEAR DTC

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B2796 or B2798 is not output.




OK

NG

3.READ VALUE USING INTELLIGENT TESTER (ENGINE IMMOBILISER SYSTEM)
3.READ VALUE USING INTELLIGENT TESTER (ENGINE IMMOBILISER SYSTEM)
a.

Use the Data List to check if the engine immobiliser system is functioning properly (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DATA LIST / ACTIVE TEST).

Immobiliser
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Immobiliser Immobiliser system status / Set or Unset Set: No key in ignition key cylinder
Unset: Key inserted in ignition key cylinder
-

OK:

Set (the key is not inserted in the ignition key cylinder) and Unset (the key is inserted in the ignition key cylinder) appear on the screen according to the key insertion condition.




OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY

NG

4.CHECK WHETHER ENGINE STARTS WITH OTHER KEYS
4.CHECK WHETHER ENGINE STARTS WITH OTHER KEYS
a.

Check if the engine starts with an already registered vehicle key.

OK:

Engine starts.




OK

REREGISTER KEY CODE OR REPLACE KEY THAT CANNOT START ENGINE

NG

5.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
5.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
a.

Disconnect the F34 ECU connector.


b.

Disconnect the F17 amplifier connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F34-14 (VC5) - F17-1 (VC5) Always Below 1 Ω
F34-15 (CODE) - F17-4 (CODE)
F34-4 (TXCT) - F17-5 (TXCT)
F34-5 (AGND) - F17-7 (AGND)
F34-14 (VC5) or F17-1 (VC5) - Body ground Always 10 kΩ or higher
F34-15 (CODE) or F17-4 (CODE) - Body ground
F34-4 (TXCT) or F17-5 (TXCT) - Body ground
F34-5 (AGND) or F17-7 (AGND) - Body ground




OK

6.REPLACE TRANSPONDER KEY AMPLIFIER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.REPLACE TRANSPONDER KEY AMPLIFIER
a.

Temporarily replace the transponder key amplifier with a new or normally functioning one (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>TRANSPONDER KEY AMPLIFIER>REMOVAL).



NEXT

7.CHECK WHETHER ENGINE STARTS
7.CHECK WHETHER ENGINE STARTS
a.

Check that the engine starts normally.

OK:

Engine starts normally.




OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)

NG

REPLACE TRANSPONDER KEY ECU ASSEMBLY