Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM1440E _58 Vehicle Interior _056158 METER / GAUGE / DISPLAY _0274083 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Engine Coolant Temperature Receiver Gauge Malfunction  


DESCRIPTION

In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication system. The meter CPU displays the engine coolant temperature, which is calculated based on the data received from the ECM.

WIRING DIAGRAM

E200189E01
5.28,2.411 7.121,2.576 1.841,0.165 10 Combination Meter Assembly 1.107,3.358 2.831,3.523 1.725,0.165 10 : CAN Communication Line 2.455,2.326 3.760,2.666 1.305,0.340 10 Engine Coolant Temperature Sensor 2.463,2.162 2.749,2.309 0.285,0.148 10 B25 0.61,2.421 0.944,2.569 0.334,0.148 10 ECM 2.511,1.676 2.628,1.824 0.117,0.148 10 1 3.515,1.668 3.632,1.816 0.117,0.148 10 2 1.237,1.79 1.511,1.937 0.275,0.148 10 B37 0.675,1.784 1.128,1.931 0.452,0.148 10 ETHW 0.784,1.185 1.124,1.332 0.340,0.148 10 THW 1.216,1.171 1.490,1.319 0.275,0.148 10 B38 1.267,0.983 1.467,1.130 0.200,0.148 10 17 1.309,1.587 1.425,1.734 0.117,0.148 10 8

CAUTION / NOTICE / HINT

HINT:

If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores the DTCs. Troubleshoot the SFI system (See page Engine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if a CAN communication DTC is output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

Result
Result Proceed to
CAN communication DTC is not output A
CAN communication DTC is output B



A

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WATER TEMPERATURE METER OPERATION)

B

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WATER TEMPERATURE METER OPERATION)
a.

Operate the intelligent tester according to the display and select the Active Test (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Water Temperature Meter Operation Engine coolant temperature receiver gauge Low, Normal, High Confirm that the vehicle is stopped with the engine idling.

OK:

Engine coolant temperature receiver gauge indication is normal.




OK

3.READ VALUE USING INTELLIGENT TESTER (COOLANT TEMPERATURE)

NG

REPLACE COMBINATION METER ASSEMBLY

3.READ VALUE USING INTELLIGENT TESTER (COOLANT TEMPERATURE)
a.

Operate the intelligent tester according to the display and select the Data List (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Coolant Temperature Engine coolant temperature/16 to 127°C (60.8 to 260.6°F) After warming up: 80 to 95°C (176 to 203°F)
·

If the value is -40°C (-40°F), the sensor is circuit open.

·

If the value is 140°C (284°F) or more, the sensor circuit is shorted.



OK:

Engine coolant temperature value displayed on the intelligent tester is almost the same as the engine coolant temperature receiver gauge indication.



b.

Record the temperature displayed on the intelligent tester.



OK

4.READ VALUE USING INTELLIGENT TESTER (COOLANT TEMP)

NG

REPLACE COMBINATION METER ASSEMBLY

4.READ VALUE USING INTELLIGENT TESTER (COOLANT TEMP)
a.

Operate the intelligent tester according to the display and select the Data List (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

Engine and ECT
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Coolant Temp Engine coolant temperature/Min.: -40°C (-40°F), Max.: 215°C (419°F) After warming up: 80 to 100°C (176 to 212°F)
·

If the value is -40°C (-40°F), the sensor is circuit open.

·

If the value is 140°C (284°F) or more, the sensor circuit is shorted.



OK:

Engine coolant temperature value displayed on the intelligent tester is almost the same as the previously recorded intelligent tester indication (Body Electrical / Combination Meter / Data List / Coolant Temperature).




OK

REPLACE COMBINATION METER ASSEMBLY

NG