Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR
RM1440E _58 Vehicle Interior _056160 SUPPLEMENTAL RESTRAINT SYSTEMS _0274098 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 89834 1.INSTALL REAR AIRBAG SENSOR LH

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



c.

Install the rear airbag sensor with the nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that the rear airbag sensor is not loose.


e.

Connect the connector.


Hide 64740C 2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 64721B 3.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM COVER

Hide 64713F 4.INSTALL FRONT DECK SIDE TRIM COVER LH

Hide 64725J 5.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 73233A 6.INSTALL REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER

Hide 58570C 7.INSTALL REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

Hide 58574A 8.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

Hide 58306A 9.INSTALL INNER FLOOR SIDE RAIL SUB-ASSEMBLY (w/ Deck Board)

Hide 58410R 10.INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)

Hide 58704A 11.INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH (w/ Deck Board)

Hide 58703A 12.INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH (w/ Deck Board)

Hide 58480B 13.INSTALL REAR NO. 2 REAR FLOOR BOARD ASSEMBLY (w/ Deck Board)

Hide 58401A 14.INSTALL NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board)

Hide 58408D 15.INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

Hide 64721B 16.INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Deck Board)

Hide 62332C 17.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 67934 19.INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

Hide 58371F 20.INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

Hide 21.INSTALL REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)

a.

Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY>INSTALLATION).


Hide 22.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CAUTION:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 23.CHECK SRS WARNING LIGHT